Primary technical performance of the valves

Time:2016-04-13 19:39:35 Views:

Strength properties of the valve

Strength properties of the valve is the valve the ability to withstand the pressure medium. Valve is subjected to inner pressure of mechanical products, and therefore must have sufficient strength and rigidity to ensure the long-term use without the risk of rupture or deformation.

Sealing performance

Valve valve sealing performance is part of the sealing ability to prevent media leaks, it is the most important technology valve performance. Sealing valve has three parts: opening and closing pieces and valve seat sealing surface between the two contact points; packing and stem and stuffing the distribution and office; body and bonnet connection. Which is called before a leak within the leak, also known as loose relationship, it will affect the ability of the valve cut off media. For the cut valve, the internal leakage is not allowed. Leakage after the two called the leak, that media leaks from the valve to the valve outside. Leakage will result in material losses, environmental pollution, will result in serious accidents. The explosive, toxic or radioactive medium, leakage is allowed, and thus the valve must have a reliable sealing performance.

Mobile Media

Medium flow through the valve will generate pressure loss (both before and after the valve pressure difference), that is, the flow valve on the media have a certain resistance, medium to overcome the resistance of the valve, it takes some energy. From the conservation of energy considerations, the design and manufacture of valves, to minimize the resistance of the valve on the flow media.
Stop force and the opening and closing torque

Stop force and the opening and closing torque is necessary for the valve to open or close the force or torque applied. Close the valve, the need to open and close the two pieces with the fat seat sealing surface of the seal formed between certain specific pressure, but also to overcome the stem and the packing between the stem and the nut thread between the stem end of the Bearing friction and other friction parts, which must exert a certain moment of closing force and closing the valve in the opening and closing process, the need to stop force, and opening and closing moments of change, and its maximum is close to the final instant or open the initial transient. Design and manufacture of valve closing force should seek to reduce and close the moment.

Hoisting speed

Opening and closing speed is an opening or closing the valve action to complete the time required to represent. Generally open and close the valve speed without strict requirements, but some conditions have special requirements on the opening and closing speed, if the requirements of rapidly turned on or off, to prevent accidents, and some asked slowly shut down to prevent water hammer and other produce This should be in the selection of valve types to be considered.

Sensitivity and reliability of action

This refers to the valve for the medium parameters, and make the appropriate degree of sensitivity. The throttle valve, reducing valve, regulating valve used to adjust the valve and safety valve medium parameters, the trap has a specific function such as the valve, its function is very important to the sensitivity and reliability of technical performance indicators.


It said the durability of the valve is a valve key performance indicators, and has great economic significance. Usually guarantee the number of seals required to open and close that can also be used to indicate the use of time.

Address:South of Jinhua Road,Shangjie District,Zhengzhou City 450041 China       Phone:+86-371-85762777      Email:sales@kingwellvalves.com

Kingwellvalves.com©2013-2015. All rights reserved. YU ICP: 豫ICP备13019442号-1 Designed by XIN LING DI